【模型小技巧】第貳拾柒篇
水貼紙軟化劑有綠蓋,也有藍蓋
到底差別在哪裡?

備註:
貼紙軟化劑沾上後請不要立刻擦拭掉
稍微等一下下或是觀察軟化程度
之後再用棉花棒吸取多餘軟化劑
最後來回滾壓直至水貼黏牢於模型表面即可

另外藍蓋的部份,因為裡頭有添加黏劑
所以我習慣先在要貼水貼的位置點上些微軟化劑
接著上水貼,並且在用棉花棒來回滾壓的同時
也順便觀察一些黏性較差的水貼
是否有牢牢的抓緊於模型表面上(無反白的情況)
最後表面如有殘膠,再用棉花棒沾清水擦式即可

※如果覺得不錯，也歡迎分享轉貼:D

[Modeling tips] No.27
What’s the different between Green(=decal softer) and Blue(=decal setter)?

Green cover: Simply the decal softer.

Blue cover: Adhesives added in, helps the decals set and attach to the surface better. The adhesives would usually precipitate at the bottom of the bottle, so it’s better to shake the bottle to make it distribute evenly.

(If there’s some adhesives left on the surface or decal after using, you can use some wet cotton swabs to clean it.)

P.S:
When you brush the decal softer on the decal, don’t wipe it off too soon, leave it a little bit longer and see how soft it goes. Then use cotton swabs to wipe the surplus softer off, roll the cotton swabs over and over until the decal is nicely attach to the surface.

And about the BLUE cover, because it added some adhesives, I usually brush some softer on the surface before put the decal on. Then roll the cotton swabs and see if some poor- stickiness decal is attach to the surface properly.

*If you think this tip is good, you are welcome to share it. :D

今天中午的時間，洛洛在台科大宣傳「Porsche Decal Desing contest」也就是保時捷舉辦的車貼創作競賽!
為新Cayman設計車身外觀貼紙
只要你為我們的保時捷車貼設計的夠特別、夠有創意
第一名的人保時捷將全額贊助你去德國!參觀保時捷的工作團隊與工廠，更可以得到許多保時捷的精美禮物喔!
http://www.codeofthecurve.com/#!/design-contest-taiwan
裡面有完整詳細的教你如何參賽與報名方法
對設計車貼有興趣的朋友們!別錯過這次的機會!!好好在保時捷新Cayman上揮灑你的創意天份吧!